Advertisement
How to program Dial to Open on the 3G GSM Keypad
Once the unit has a
ID command so only authorised numbers you store can activate the unit.
If the ID Command is switched OFF anyone phoning the units number can operate the
Gate.
The caller ID function is switched on and off via the text commands as follows
#ID=ON#
Turns caller ID on.
#ID=OFF#
Turns caller ID off.
To program a number into the caller ID (whl) list you will need to send the text message
code:
#WHL#NUMBER#
To delete the number send a text message code:
#DEL#NUMBER#
Example
#WHL#07123456789#
Example
#DEL#07123456789#
If the code is accepted the unit will reply "WHL number stored" or "WHL number deleted"
PLEASE NOTE YOU CAN ONLY SEND ONE NUMBER AT A TIME.
Please send the message and wait for the unit to reply with the acknowledgement
text "STORED" before you try to add another number via the text entry.
Please ensure that you have credit on your simcard to receive the text acknowledgment.
It may take some time to receive the text acknowledgement. This can depend upon how
busy your telephone network is at the time.
For a quick reset and to clear all numbers there is a built in reset function that is triggered
via sending the sms text message.
#RESET#
Will reset back to factory settings
The unit will then remove all WHL numbers stored and keypad codes
www.gsm-activate.co.uk
green
light it is ready to be used. The unit can be set by sending the
Caller ID Function
to store your authorised number. (Maximum 50 users)
to delete authorised number.
Reset Function
- 01273462380 - sales@gsm-activate.co.uk
Page 4
Advertisement
