Lubrication Of The Shredder; Maintenance - Kensington OfficeAssist Instruction Manual

OfficeAssist Shredding Capability
CAN shred the following:
• Stapled paper, 1 inch / 25 mm within the corner
• 26/6 and 24/6 or smaller staples
• Small sized paper
• Paperclipped paper, 1 inch / 25 mm within the corner
• Capable of shredding small/medium paperclips
(max. wire thickness = .035 inches / .9 mm)
• 65-100gsm paper
CAN shred (through the manual feed slot):
Thick paper or card
<200gsm
CANNOT shred the following:
Heavy duty staples.
Check the staple leg
length is not greater
than .23 inches / 6 mm.
Bulldog clips
Adhesive labels
No aerosols

Lubrication of the Shredder

Kensington recommends using an oil sheet after the bin has been
emptied three times (and every three bin emptying after this).
Insert the oil sheet into the manual feed slot and NOT in
the auto-feed chamber. Using an oil sheet in the auto-feed
chamber will contaminate the feed rollers preventing the
auto-feed mechanism shredding. Follow the maintenance
instructions if the rollers become contaminated.
8
Glossy paper or a sheet
covered with print on both
sides.
Large clips. Check the length
of the paperclip is not longer
than 1.25 inches / 32 mm.
Bound documents
No Liquid Oil

Maintenance

The rollers on the auto-feed mechanism may become dirty
over time, please wipe clean with a dry cloth to maintain
maximum product performance.
The auto-start infrared sensor, located in the paper feed
entry-slot, can occasionally become covered in paper-
dust causing the shredder to run despite no paper being
fed into the machine. Switch the shredder off at the rear
of the machine and carefully clean the sensor using a
cotton-swab.
• 11'' x 17'' folded in half max. 2 sheets
• 300 sheets
• 80gsm paper
- Letter - 8.5" x 11"
- 1/2 Sheet - 5.5" x 8.5"
- Tabloid - 11" x 17"
Multiple folded sheets
(11'' x 17'' sheets folded
in half).
Plastic sheets,
laminated documents,
plastic folders.
Magazines or other
documents bound by
multiple staples or clips.
No CDs & DVDs
English