F&P myAirvo 2 Quick Start Manual

4. Consumable parts
Please refer to Section 4, "Cleaning and maintenance", of your myAirvo 2 User Manual for information on
consumable parts. myAirvo 2 has five parts which you will need to replace regularly to keep your device
as clean as possible. The times recommended below assume your myAirvo 2 is only being used by one
person, and rely on the correct cleaning procedures being followed.
Optiflow™+ nasal cannula
60
Replace every 60 days.
Product code: MYOPT9SMALL (2-pack)
Reorder code:
AirSpiral™ tube and auto-fill chamber kit
60
Replace every 60 days.
Product code: MYAIRVOKIT1
Water bag
60
Replace every 60 days.
Product code: 900PT401 (2-pack)
Air filter
90
Replace every 90 days or 1000 hours.
Product code: 900PT913 (2-pack)
Some products may not be available in your country.
Please contact your local Fisher and Paykel Healthcare representative.
Contact details for support and ordering
www.fphcare.com/myairvo
F&P, AirSpiral, myAIRVO, myAirvo and Optiflow are trademarks of Fisher & Paykel Healthcare Limited.
For patent information, see www.fphcare.com/ip
MYOPT9MEDIUM (2-pack)
MYOPT9LARGE (2-pack)
myAirvo™ 2 Quick Start Guide
Important note: This is a Quick Start Guide only and should not be considered in any way a replacement
for your myAirvo 2 User Manual. Before using your myAirvo 2 device you must read your myAirvo 2 User
Manual to understand the device's intended use, warnings and cautions. myAirvo 2 is not intended for life
support.
1. How to set up your device
Please refer to Section 2, "Setting up myAirvo 2", and Section 3, "Using myAirvo 2", of your
myAirvo 2 User Manual for information on setup.
Place your myAirvo 2 on a
1
low shelf or near the floor
beside your bed. Make
sure it is placed below your
head height and flat.
a. Remove the blue port
2
tabs and water supply
tube holder.
b. Install the
b
elbow adapter to the
a
MR290 water chamber.
c. Clip the water supply
tube into position.
c
Fit the water chamber onto
3
your device by depressing
the finger guard, pushing
forward until the finger
guard clicks into place.
a. Hang water bag from
a
4
the home stand.
b. Push water supply tube
spike into the fitting at
the bottom of the water
bag. Open vent cap.
b
c. Water will enter MR290
water chamber and be
contained below
max water level line.
Attach the breathing tube
5
to your myAirvo 2.
Auto-fill chamber
Plug myAirvo 2's power
6
cord into the mains/utility
power socket and into the
rear of the unit.
Switch on myAirvo 2 by
7
pressing
the On/Off button for 5
provided seconds.
myAirvo 2 will begin to
8
warm
warm-up symbol on the
screen.
When myAirvo 2 is ready
9
for you to use, a tick
symbol will be displayed.
the
Connect
10
and begin therapy. During
use, if excess condensate
forms in the tube, refer to
Condensate Management
in Section 2, "Setting up
myAirvo 2".
Nasal cannula
and holding
up, displaying a
your interface