Memory Clear - Furuno IF-NMEASC Operator's Manual

Self test 2
This test checks this unit's processor and output for proper operation.
1. With the display showing " - - - .1", push the [Menu/Cancel] button. The display shows "- - - 2".
GPS OUTPUT PROCESSING
SENSOR1
2. Press the [Enter] button to start the test.
If the results are normal all LEDs light. Then, the nine LEDs below the display flash and the
display shows "End.2".
3. Press the [Enter] button to return to the self test 2 display.
5.5

Memory Clear

The memory can be cleared to restore the default settings for the NMEA ports. Note that offsets
are not cleared.
1. Hold down the [Menu/Cancel] button together with the [+] button until the display shows "-
CLR". At this time all Status and Settings LEDs are on.
2. Press the [Enter] button to clear the memory and restore all default settings. "END C" appears
upon completion.
3. After the memory is cleared, press the [Menu/Cancel] button to show the heading.
Heading
Pitch
Sentence Bps
Sentence Bps
Menu/
Enter
Cancel
GPS OUTPUT PROCESSING
SENSOR1
C
Heading Pitch
Sentence
Sentence
Menu/
Enter
Cancel
5. MAINTENANCE, TROUBLESHOOTING
IF-NMEASC status
SENSOR2
Self test 2 activated
Roll
Output
Interval
Output
Interval
- +
STATUS of IF-NMEASC
SENSOR2
L R
Roll
Output
Bps
Interval
Output
Bps
Interval
- +
13