Cleaning A Carpet; Tips For Carpet Cleaning - Easy@Home VC9385S User Manual

Operation

Cleaning a carpet

• Before cleaning, determine where to start and stop, making sure
• Do not oversaturate the carpet with cleaning solution.
• For heavily soiled areas, additional applications may be necessary.
1. Plug the mains cord
the on/off switch
2. Step on the handle release pedal
position (see Fig. D).
3. While pressing the solution release trigger
direction towards you.
4. Release the solution release trigger and push the product forwards in the same
path to remove the dirty cleaning solution from the carpet.
5. Repeat steps 3–4 to clean other parts of the carpet or heavily soiled areas.
6. When cleaning is done, turn the product off by setting the on/off switch to the
OFF position (O).
7. Push the handle forwards until it is positioned upright and locked into place.
8. Unplug the product and wrap the mains cord around the cord hooks

Tips for carpet cleaning

• Use the carrying handle
cleaning location.
• Do not run the product over the mains cord
your free hand while cleaning.
• Use a steady, moderate, forwards and backwards motion.
• Always work from back to front across a room to avoid stepping on wet carpet.
• Do not make the carpet too wet. Use no more than two sets of forwards and
backwards strokes while releasing carpet cleaning solution. Always follow with
dry strokes; the more dry strokes the better.
• Wipe any cleaning solution from woodwork and furniture to prevent any
damage.
• Allow plenty of time for the carpet to dry and avoid walking on it until it is dry.
• Increased air circulation (open doors, fans, etc.) or the use of a dehumidifier will
help the carpet dry thoroughly and prevent the growth of mold or mildew.
• Vacuum the carpet thoroughly before cleaning it and after it has dried.
14
you will not walk over previously cleaned areas.
16
into a mains socket and turn the product on by setting
5 to the ON position (I).
15
to lift up the product and move it to the desired
17 to lower the handle
2
, pull the product in a backwards
16
by holding any excess cord in
1 into the cleaning
14 .