I
1
2
I
3
Figure 19 WIRING SIDE OF P.W.9OAP.D (2/21
I
I
5
I
4
NOTES ON SCHEMATIC DIAGRAM
To differentiate the units of resrstors,
used: the symbol K means 1000 ohm and the resistor
Capacitor:
To indicate the unit of capacitor, a symbol P is used: this
symbol P means picofarad and the unit of the capacitor
capacitor, the expression "capacitance/withstand voltage" is
used.
type
The indicated voltage !n each sectfon IS the one measured by
1. Tuner
2. IClOl
II:
Marking except for ( 1
Tape 1 mode
3. Q-251
Record mode
4 . 0 1 5 2
5. M501 (Motor)
Parts marked with "A" ("I") are important for maintaining
the safety of the set. Be sure to replace these parts with
specified ones for maintaining the safety and performance
of the set.
Schematic Diagram and Wiring Side of P.W.Board for this
model are sublect to change for improvement without prior
SR
K
6
I
such symbol as K is
As to electrolytic