Advertisement
Thank you for purchasing the JJC JF-U Series 3 in 1 Wireless Remote Control & Flash
Trigger Kit.
The JF-U Series 3 in 1 Wireless Remote Control & Flash Trigger Kit is a versatile and
reliable remote control kit that can be used as a Wired Remote Control, a Wireless
Remote Control or a Wireless Flash Trigger. It triggers off-camera flash units and studio
lights from up to 30meters / 100 feet away.
Replacing Batteries
1.
Slide open the battery covers of transmitter and receiver respectively in the direction
of OPEN ARROW on the battery covers.
Advertisement
Table of Contents
Subscribe to Our Youtube Channel
Related Manuals for JJC JF-U Series
Summary of Contents for JJC JF-U Series
- Page 1 Thank you for purchasing the JJC JF-U Series 3 in 1 Wireless Remote Control & Flash Trigger Kit. The JF-U Series 3 in 1 Wireless Remote Control & Flash Trigger Kit is a versatile and reliable remote control kit that can be used as a Wired Remote Control, a Wireless Remote Control or a Wireless Flash Trigger.
- Page 2 Put one 23A battery into the battery compartment of the transmitter, and two AAA batteries into compartment of receiver as directions shown in pictures below. Do not install batteries in the reverse direction. (Note: If there is inconsistency between the battery brands in the picture and those supplied in the package, the actual product shall govern.) Make sure batteries are fully in place and slide back the battery covers of transmitter...
- Page 3 Channel setting Note: Please make sure the Transmitter and Receiver are adjusted to the same channel before using. There are 16 channels select-able for Transmitter and Receiver. Slide open the battery covers and set channel codes of Transmitter and Receiver to the same position. The following channel is one of available channels.
- Page 4 Please set the desired power output on the flash manually. Wireless Shutter Release Note: This function requires the use of a JJC shutter release cable (purchased separately). Check the enclosed Connecting Cable Brochure for the cable you need.
- Page 5 Then fully press the release button, the indicators will turn red and the camera shutter is triggered. Wired Shutter Release Note: This function requires the use of a JJC shutter release cable (purchased separately). Check the enclosed Connecting Cable Brochure for the cable you need.
- Page 6 Turn off the camera. Then connect one end of the shutter release cable to the ACC1 socket of transmitter and the other end to camera remote socket . Turn on the camera. Half press the release button on the transmitter to focus and fully press to trigger camera shutter.
- Page 7 FCC Statement This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications.
Need help?
Do you have a question about the JF-U Series and is the answer not in the manual?
Questions and answers