Frigidaire Beverage Center Refrigerator Use & Care Manual page 4

BEVERAGE DELIVERY KIT BOX
(9) Faucet and Shank Assembly
( 10) Plastic Collar
( 11) Shank Nut
(12) Faucet Knob
( 13) Regulator
( 14) Keg Coupler
(15) Clear Hose (Delivery Line)
(16) Red Hose (Gas Line)
(17) Rubber Washer (Black)
( 18) Plastic Hose Clamp (White)
( 19) CO Canister (Empty)
2
(9) FAUCET & (10) PLASTIC
SHANK ASS'Y. COLLAR
(13) REGULATOR (14) KEG
COUPLER
(17) RUBBER
WASHER
(18) HOSE
CLAMP
LEVELING
The beverage cooler must have all bottom corners resting
fi rmly on a solid floor. The floor must be strong enough to
s upport a fully loaded beverage cooler. NOTE: It is
Im portant for your beverage cooler to be level in order to
fu nction properly. If the beverage cooler is not leveled during
in stallation, the door may be misaligned and not close or seal
p roperly, causing cooling, frost, or moisture problems.
To Level Your Beverage Cooler:
C arefully tip the unit onto its back. Remove and discard the
w ood skid from the bottom using a 3/8" socket wrench. After
d iscarding crating screws and wood skid, use a carpenter's
le vel to level the beverage cooler from front to back. Adjust
th e plastic leveling feet in front, ½ bubble higher, so that the
d oor closes easily when left halfway open.
1 piece
1 piece
1 piece
1 piece
1 piece
1 piece
1 piece
1 piece
2 pieces
2 pieces
1 piece
(1 1) SHANK NU T (12) FAUCET
KNOB
(15) CLEAR HOSE (16) RED HOSE
(GAS LINE)
(DELIVERY LINE)
(19) CO
2
CANISTER
Very
INSTALLATION – GENERAL INSTRUCTIONS
• Choose a place that is near a grounded electrical outlet.
DO NOT use an extension cord or an adapter plug.
• For the most efficient operation, the beverage cooler
should be located where surrounding temperatures will not
drop below 10ºF (-12ºC) or exceed 110ºF (43ºC).
• Allow space around the unit for good air circulation. Leave
a 3 inch (75 mm) space on all sides of the beverage cooler
for adequate air circulation.
NOTE: The exterior walls of the beverage cooler may
b ecome quite warm as the compressor works to transfer heat
f rom the inside. Temperatures as much as 30ºF warmer than
t he room temperature can be expected. For this reason it is
p articularly important in hotter climates to allow enough
s pace for air circulation around your beverage cooler.
4