Sharp XL-G5000V Service Manual page 14

2. CD MECHANISM SECTION
Perform steps 1 to 2 and 14 to 15 of the disassembly method to
remove the CD mechanism.(see page 3-3,3-4)
2.1. How to remove the Optical Pickup (See Fig. 1)
1. Remove the stop washer (A1) x 1 pc and gear (A2) x 1 pc.
2. Remove the screws (A3) x 2 pcs and shaft (A4) x 1 pc.
3. Remove the optical pickup.
NOTE: After pulling out the optical pickup connector, wrap the tip of it
with conductive aluminium foil or the like to protect the optical
pickup from the static electricity.
2.2. How to remove CD Disc (See Fig. 2~6)
1. When CD is at play position, rotate reduction gear C clock-wise as
shown in Figure 2 Until disk tray is at 'STOCK' position, then rotate
the gear further to eject the disk tray (Figure 6) so that CD can be
removed from the tray.
2. In another case, if CD mechanism is at tray No. 1 play position and
to remove CD located in tray No. 3, the procedure is as follows:
If the gear up down board is located at tray No. 1 position, then
rotate Reduction gear C clock-wise until Disc tray is at stalk
'STOCK' position. Rotate reduction gear D clock-wise (Figure 3) to
move the CD mechanism to tray No. 3 position. This is confirmed
by checking the gear up down board position Base on the marking
as indicated on the main chassis as shown in Figure 4.
• Usually changer is covered with top plate. As for reference pur-
pose, we exclude the top plate for easy viewing. (Figure 5,6)
Disc Tray
Guide Tray
CD At play position.
CD Disc
CD At 'STOCK' position.
Figure 5
CD Disc
Remove CD from tray.
Figure 6
CD Disc
Tray eject
Stop Washer
(A1) x1
Optical Pickup
CD
Mechanism
Reduction gear C
Gear up down board
3 – 2
XL-G5000V/XL-G5000V(S)
(A3) x2
ø2.6 x5mm
Shaft
(A4) x1
Gear
(A2) x1
Figure 1
Front Rear
Figure 2
Reduction gear D
Up Down
Figure 3
Mark 1 Mark 3 Mark 5
(DISC 1) (DISC 3) (DISC 5)
Mark 2 Mark 4
(DISC 2) (DISC 4)
Figure 4