Charging Your E-Bike; Care Of Battery - Tao Motor Libra 604 User Manual

If you have to cover long distances and at the same time want to save electricity than you
must have to follow these driving habits.
● When you are going downhill or moving on a flat road surfaces try your best to use
bikes' momentum and permit the bike to coast, without taking off the power of motor.
● Prefer to avoid stop and go movements because motor takes more power when it starts
from an absolute point.
● Avoid burdening the bike because due to this motor draws power too.
● Tires must have proper air pressure because it lessens the dragging and increases the
efficiency of bike.
● If head and tail lights remained on, it would reduce the power and bike could cover
distance by about 5% only.
● Acceleration from absolute point will draw more power. To avoid this try pedaling
Charging e-bike requires a simple procedure.
● The charger given with your e-bike.
● 110V household electrical outlet.
WARNING:
Never use batteries that are identical to the battery given with your e-bike. Use only battery
given with your e-bike Otherwise it will cause serious damage to your electric system and also
can harm you.
FOLLOW THESE STEPS TO CHARGE YOUR BATTERY:
● Switch off your bike and take the key out of the ignition.
● Plug the female end of the charger cable that is located on the outside casing of the e-
bike present underneath the seat into the charging slot on the e-bike.
● Plug the male end of the charger cable into the wall socket. It should contain 110V
electric supply. Portable generators can also be used but make sure it should have 110
V. Also charge you battery for about 6-8 hours.
● When the LED light on the charger glows, disconnect it because it shows that battery
has been fully charged.
"IF LED LIGHT ON THE CHARGER IS NOT TURNING INTO GREEN PROLONGEDLY AND BATTERY
ALSO GETTING HOT, THAN YOU SHOULD REPLACE IT OR TOOK IT TO YOUR LOCAL TAO
MOTOR DEALERS"

CARE OF BATTERY:

CHARGING YOUR E-BIKE.

Page
9