Axis M30 Series User Manual page 13

AXIS M30 Network Camera Series
Configure your device
3. Select the Condition that must be met to trigger the action. If you specify more than one condition for the rule, all of the
conditions must be met to trigger the action.
4. Select which Action the device should perform when the conditions are met.
Note
If you make changes to an active rule, the rule must be turned on again for the changes to take effect.
Note
If you change the definition of a stream profile that is used in a rule, then you need to restart all the rules that use that
stream profile.
Record video when the camera detects an object
This example explains how to set up the camera to start recording to the SD card five seconds before it detects an object and to
stop one minute after.
1. Start the application if it is not already running.
2. Make sure you have set up the application according to your needs.
Create a rule:
1. Go to System > Events and add a rule.
2. Type a name for the rule.
3. In the list of actions, under Recordings, select Record video while the rule is active.
4. In the list of storage options, select SD_DISK.
5. Select a camera and a stream profile.
6. Set the prebuffer time to 5 seconds.
7. Set the postbuffer time to 1 minute.
8. Click Save.
Send an email automatically if someone spray paints the lens
Activate the tampering detection:
1. Go to System > Detectors > Camera tampering.
2. Set a duration for Trigger after. The value indicates the time that must pass before an email is sent.
3. Turn on Trigger on dark images to detect if the lens is sprayed, covered, or rendered severely out of focus.
Add an email recipient:
4. Go to System > Events > Recipients and add a recipient.
5. Type a name for the recipient.
6. Select Email.
7. Type an email address to send the email to.
8. The camera doesn't have it's own email server, so it has to log into another email server to send mails. Fill in the rest of the
information according to your email provider.
9. To send a test email, click Test.
13