Table of Contents
Advertisement
Quick Links
EN
GENERAL FEATURES
Input current 0 - 20 mA or 4 - 20 mA.
Two-wire sensor supply:
20V , 20mA max protected against short circuit.
~
Measure and retransmission or analog insulated output,
current output 0 - 20 mA or 4 - 20 mA.
Front power supply presence indicator.
Safety i s lation 300 V
n u
TECHNICAL FEATURES
Environemental conditions
- Temperature:
- Humidity:
- Storage temperature:
- Protection degree
Box specification
- Dimensions and weight:
- Material:
Errors referred to
Input's measure range:
Connections:
Response time:
Input protection:
Protection
Output / Power supply:
Insulation:
Z109S-DI
GALVANIC SEPARATION
WITH
CURRENT LOOP
CAT II
~
10 - 40 V
Current 0 - 20 mA or 4 - 20 mA, 20 V
loop supply, input impedance ~50Ω
Current 0 - 20 mA or 4 - 20 mA, loop impedance < 600Ω
From -20 to +60 °C.
min: 30%, max 90% no condensing
From -30 to +85 °C
IP20
100 x 112 x 18mm, 130g
PA6, Black colo r u
Calibration
0.2%
Removable 3-way screw terminals, 5 mm pitch.
cable section's 0.25-2.5 mm²
<200us, cutoff frequency (-3dB) 6kHz
30V continuous.
Against surge pulses 400 W / ms
Safety insulation < 300 V
Test voltage 3500 V
, 19 - 28 V
~
(
see the
T erm
o
10 A
µ
~
MI003422-E
50-60Hz, max 2.5 W.
~
± 10%
~
n
h
al c
oeff
.
0.02%/°K
referred to ground CAT II
~
3-way
ENGLISH - 1/4
section
)
.
EMI
<1%
Advertisement
Table of Contents
Related Manuals for Seneca Z109S-DI
Summary of Contents for Seneca Z109S-DI
- Page 1 Z109S-DI GALVANIC SEPARATION WITH CURRENT LOOP GENERAL FEATURES Input current 0 - 20 mA or 4 - 20 mA. Two-wire sensor supply: 20V , 20mA max protected against short circuit. Measure and retransmission or analog insulated output, current output 0 - 20 mA or 4 - 20 mA.
- Page 2 ACTIVE INPUT: use this for the two-wire connection of transducers. 7 8 9 The transducer is directly powered by the Z109S-DI module 20V , 20mA max., protected against short circuit. PASSIVE INPUT : use this connection if the input current is external 7 8 9 (external loop power supply).
- Page 3 OUTPUT ACTIVE OUTPUT : use this connection when the output loop is to be powered directly from the Z109S-DI module. The Z109S -DI module can supply a maximum load of 600 Ω, with loop power supply protected against short circuit.
- Page 4 This document is property of SENECA s r l. Duplication and reprodu tion are forbidden, if not authorized. The content of this documentation refers to products and technologies described in it. All technical data contained in the document may be modified without prior notice.
Need help?
Do you have a question about the Z109S-DI and is the answer not in the manual?
Questions and answers