FLO-DYNAMICS TTCF-9A Quick Start Instructions

This machine uses hot hydraulic fluid under pressure. Check the security of all hoses and connections before operation.
Only use the same hydraulic fluid as used in the hydraulic system being flushed. DO NOT use mineral spirits, solvents, or any other volatile
liquid.
Always wear safety glasses, protective gloves, and proper clothing when operating the flusher.
If hydraulic fluid gets in your eyes or on your skin, rinse with water immediately and seek medical attention if needed.
WARNING: Improper use of this machine can result in burns and other serious injuries. Always wear eye protection and protective clothing,
and follow instructions to prevent potential injury.
Fill the tank with 9 gallons of hydraulic fluid. Check the level
with the dipstick (without threading in) to ensure the fluid
level is between the high- and low-level marks.
WARNING: DO NOT OVERFILL or run with fluid level
above the high-level mark.
Plug the machine into a 20A grounded circuit without
anything else plugged in or being used on the circuit. If a
dedicated 20A circuit is not available, use two separate
dedicated 15A outlets.
Connect the flusher to 100-125 PSI shop air.
Move the Reverser Valve to the bypass (middle) position.
CAUTION: Make sure the reverser valve is in the
neutral/bypass position prior to preheating.
Use the MODE button to select "START PREHEAT
HEATER & PUMP" and select "CONT" using the RUN
TIME button.
Check the following:
Secure fill cap
o
Secure filter screen
o
Check fluid level
o
Check all connections
o
Set flow rate
o
Set flow direction
o
Press the START/PAUSE button to begin heating the
flusher while connecting the services hoses.
Flo-Dynamics, Inc. • 3300 Reedy Drive • Elkhart, IN 46514 • 800-303-5874
TTCF-9A
Variable High Flow Heated
Hydraulic Component Flusher
OPERATION
SAFETY RECOMMENDATIONS
FLUSH PROCEDURE
40201409
QUICK START
INSTRUCTIONS
Page 1 of 5