G.I.KRAFT GI35112 Owner's Manual page 9

jump-start connection
GI35112
24Vjump-start connection
2 、 Jump-starting
1) 、 Select 12V or 24V
2) 、 Connect work cables to battery charger terminals as above diagram,and then
connect clips from battery charger to the terminals of battery
3) 、 Connect input power.
4) 、 For high power engines, fast charge the battery for 15mins before jump-start-
ing to get the best result .For diesel engines,pre-heat spark plug before jum-
p starting. For cables connections,connect negative post(-)first,and then pos-
itive post(-).
5) 、 Connect work cables to battery charger terminals while current adjustment knob
in"0"position,and then turn current adjustment knob to max.position to jump-
start the engine. If car engine cannot start after 3-4 times jump-start operat-
ions. Please speedy charge the battery for 15 mins before jump-start again.
Note:
1 、 The positive clip from battery charger must connect to positive post (+) of
battery,and connect negative clip to negative post(-)
2 、 Do not use the connections of charging to jump-start engine,otherwise it will
damage ammeter and fuse
3 、 If charger can not jump start engines check input power cord to meet mannfac-
turer's requirements.or the connections of work cables.
:
-
12
12V
2 4 +
12+
24-
j
ump-start connection
P age.7