Configuring The Xpico; Xml Programming - Canary MLBase User Manual

3.3 Configuring the xPico

Once connected using PuTTY, the most efficient way to configure the device is by updating the pre-configured XML
script in this section. Once the outlined updates have been made the XML can be copying and pasting it into the
command terminal.
Alternatively, if you are unable to access the pre-configured XML, manually entering CLI commands is also an
option. This can be a time-consuming task and requires accuracy.
Both options are outlined in this section.

XML Programming

The highlighted portions of the XML indicate network settings that need to be updated prior to copying the XML.
After updating the highlighted items within the script, copy the entire XML (on this page and the following three) and
paste the copied text into the PuTTY command terminal.
Note - When copying the XML from this document, if all three pages are copied at once, the page headers and footers will
also be copied. These should be removed when pasted in to the command terminal.
<?xml version="1.0" standalone="yes"?>
<!-- Automatically generated XML -->
<!DOCTYPE configrecord
<!ELEMENT configrecord
<!ELEMENT configgroup
<!ELEMENT configitem
<!ELEMENT value (#PCDATA)>
<!ATTLIST configrecord version CDATA
<!ATTLIST configgroup name CDATA
<!ATTLIST configgroup instance CDATA
<!ATTLIST configitem name CDATA
<!ATTLIST configitem instance CDATA
<!ATTLIST value name CDATA
]>
<configrecord version
<configgroup name
<configitem name
<value>Disabled</value>
</configitem>
<configitem name
<value>192.168.0.1/24</value>
</configitem>
<configitem name
<value>1460
</configitem>
<configitem name
<value name
<value name
</configitem>
</configgroup>
<configgroup name
<configitem name
<value>Enabled</value>
</configitem>
<configitem name
<value>Disabled</value>
</configitem>
<configitem name
<value>192.168.0.203/24</value>
</configitem>
<configitem name
<value>192.168.0.1</value>
</configitem>
MLBase User's Guide
Section 3 - xPico Configuration
[
(configgroup+)>
(configitem+)>
(value+)>
#IMPLIED>
#IMPLIED>
#IMPLIED>
#IMPLIED>
#IMPLIED>
#IMPLIED>
= "0.1.0.1">
= "Interface" instance
= "State">
= "IP Address">
= "MSS">
bytes</value>
= "DHCP IP Address Range">
= "Start">&lt;Minimum&gt;</value>
= "End">&lt;Maximum&gt;</value>
= "Interface" instance
= "State">
= "DHCP Client">
= "IP Address">
= "Default Gateway">
= "ap0">
= "eth0">
23