Advertisement
INSTALLATION (IN-DASH MOUNTING)
The following illustration shows a typical installation. However, you should make adjustments corresponding to your specific car. In this case consult the manual included with the installation kit.
In some case, depending on the type and the model of your car, it is not possible to install the unit into the center console. If you have any questions or require information regarding installation kits, consult your JVC
car audio dealers or a company supplying kits.
• If you are not sure how to install this unit correctly, have it installed by a qualified technician.
Before installing the unit
• When mounting the unit, be sure to use the screws provided, as instructed. If other screws are used, there is a possibility that parts could become loose or damaged.
• When tightening screws or bolts be careful not to pinch any connection cord.
1
Remove the audio system originally installed together with the mounting brackets.
Note: Be sure to keep all the screws and parts removed from your car for future use.
2
Attach the mounting brackets (removed from the car), to this unit (see below).
3
Connect the wires (see diagram ).
4
Fix this unit to the car using the screws removed in step 1.
• See "Caution" below.
The following example shown is for installation in a Toyota. For more details, consult your JVC car audio dealer.
Securely connect the ground wire to the metal body of the car using the
screw originally fixed to the metal body of the car.
Mounting bracket removed from the car
Screws supplied for this unit
Screws supplied for this unit:
Select the proper screw type, fitting to your car.
Caution:
To install the mounting brackets to the unit, use only the supplied screws (M5 × 8 mm).
If you use any screw longer than 8 mm, the unit can be damaged.
If there is an interfering tab on the mounting bracket,
bend it flat.
Mounting bracket removed from the car
Binding screws (M5 × 8 mm)
Install the unit at an angle of less than 30°.
2
Screws supplied for this unit
1
Screw removed from the car in step
Flat countersunk screws (M5 × 8 mm)
Advertisement
