Related Manuals for Salter Labs SALTER AIRE Plus 8350
Summary of Contents for Salter Labs SALTER AIRE Plus 8350
- Page 1 ® SALTER AIRE Plus COMPRESSOR ® Model 8350 / 8352 / 8353 Instruction Manual Page 1 of 9 ...
-
Page 2: Table Of Contents
TABLE OF CONTENTS Introduction…………………………………………………………….………………..3 Important Safeguards…………………………………………………………………..3 System Components………………………………………………….………………..5 Setup and Operation………………………………………………….………………..5 Setup……………………………………………………………….………………..5 Operation…………………………………………………………..………………..6 Cleaning and Storage………………………………………………………………….6 Compressor Cleaning……………………………………………………………..6 Nebulizer Cleaning………………………………………………………………...7 Storage....................………7 Maintenance……………………………………………………………………………7 Filter Change………………………………………………………………………7 Service……………………………………………………………………………...7 Specifications…………………………………………………………………………..8 Accessories…………………………………………………………………………….8 Warranty ..................……………….9 DEVICE INFORMATIONS Record the following information for easy reference regarding your SALTER AIRE PLUS™... -
Page 3: Introduction
The SALTER AIRE PLUS ® Compressor generates compressed air to turn your liquid medication into an aerosol mist that penetrates into your lungs. Used in conjunction with a nebulizer supplied by Salter Labs, you can be assured that you are using the finest quality products to deliver your medication. - Page 4 Connect the device to an outlet on a circuit different from that which the other device(s) are connected. Consult your Salter Labs dealer or authorized service center for help. NOTE – The compressor employs an automatic reset thermal limiter that shuts off the entire device if the motor overheats.
-
Page 5: System Components
NOTE – Always wash your hands before you begin treatment. NOTE – Always have at least two Salter Labs nebulizers on-hand available for use. SETUP 1. Remove the compressor from its (optional) carrying case. Place the compressor on a level, sturdy surface. -
Page 6: Operation
Inhale deeply and slowly as the aerosol begins to flow. Hold your breath for several seconds, then exhale slowly. 4. If a Salter Labs aerosol mask is being used, position the mask over your nose and mouth. Inhale deeply and slowly through your mouth as the aerosol begins to flow. -
Page 7: Nebulizer Cleaning
Your SALTER AIRE PLUS ® Compressor has an inlet air filter to remove airborne contaminants. The filter requires periodic replacement. The compressor comes with a package of extra inlet filters for this purpose. Contact your local Salter Labs dealer to obtain additional filters. -
Page 8: Specifications
Contact your Salter Labs dealer or authorized service center if your unit needs repair. WARNING – Do not tamper with or attempt to repair the device. Refer servicing to qualified service personnel. SPECIFICATIONS Specifications and appearance are subject to change without notice. -
Page 9: Warranty
Authorized Representative in the E.U.: MT Promedt Consulting GmbH Altenhofstrasse 80 D-66386 St. Ingbert 0482 Germany Salter Labs, Salter Aire Plus, NebuTech, and the Salter Labs logo are trademarks of Salter Labs 801562 Rev. F Page 9 of 9...
Need help?
Do you have a question about the SALTER AIRE Plus 8350 and is the answer not in the manual?
Questions and answers