1.Safety Precaution (1) When moving or laying down a LCD Set, at least two people must work together. Avoid any impact towards the LCD Set. (2) Do not leave a broken LCD Set on for a long time. T o prevent any further damages, after checking the condition of the broken Set, make sure to turn the power (AC) off.
2.Preliminary Troubleshooting 1) LCD TV does not response or remote controller does not work. - Check the power cord to be plugged. - Check the battery of the remote controller. 2) Sound is discontinuous or broken sometimes. - Set the sound effect into 'MONO'. - Set the [SOUND] ->...
4.Board Layout main pcb top CN26 CN15 CN10 Power pcb Power pcb Control pcb LCD LVDS speaker Main board rear view CON8 Hdmi2 Hdmi1 Pc RGB Pc audio CATV earphone Main board side view Video in Y Pb Pr Jinyoung Electronics co.,ltd...
Page 7
Main board dimension Power board view <32inch> Power input Main pcb LCD panel Main pcb Jinyoung Electronics co.,ltd...
<39inch> Main board terminal description RF Input 1 IEC 75Ω PC-RGB Input D-SUB15Pin terminal Input YPBPR Input RCA terminal T erminals HDMI Input HDMI terminal USB terminal AV Input RCA terminal Ouput 1earphone terminal EarphoneT erminal Output 5.Connector -CN26: Main Board Power Supply SYMBOL DESCRIPTION GND 12,13...
Page 9
CN7: IR and LED board Interface PIN No. Definition Description CN7-1 KeyA/K7 POWER /RESERVED KeyB/K6 POWER Volume up Vo;ume down SOURCE Ch up Ch down MENU Ground CN7-2 LED-GREEN Green Indicator LED-RED Red Indicator +5V DC Power Supply CN5: Backlight control PIN No Definition Description...
Page 10
CN15: LVDS Output PIN No Definition Description VCC-Panel Power supply for panel VCC-Panel Power supply for panel VCC-Panel Power supply for panel Ground Ground Ground RXO0- L VDS ODD 0- Signal RXO0+ L VDS ODD 0+ Signal RXO1- L VDS ODD 1- Signal RXO1+ L VDS ODD 1+ Signal RXO2-...
6.Software Update Steps Step1: Copy merge_6M181.bin file to USB disk, and then plug the disk to USB slot. Step2: Power on the LCDTV . Step3: Press MENU key,then left or right key, call the main menu as below Step2: Use up or down key, move the highlight bar to Software Update(USB) and press OK key.
Need help?
Do you have a question about the EF3912 and is the answer not in the manual?
Questions and answers