Before Using This Product - T&D TR-57DCi User Manual

Harmful gases or chemicals may cause corrosion and/or
other danger to the Unit. Also, by coming into contact with
hazardous substances, harm may occur to the people
Forbidden
handling the Unit. Therefore, do not use or store it in any
environment that is exposed to chemicals and harmful
gases.
To prevent damage to the Unit from static electricity,
remove static electricity from your body by touching metal
around you (door knob, window frame) before touching the
Strictly Follow
Unit. It may cause data loss or damage to the Unit and data.
Do not use or store the Unit in any of the following places.
Doing so may cause electrocution, fire, and other adverse
effects to the Unit and/or your computer.
Forbidden
- Areas exposed to direct sunlight
This will cause the inside of the Unit to become over-
heated and may cause fire, deformation, and/or other
damage including malfunction.
- Areas exposed to strong magnetic fields
This may cause damage including malfunction.
- Areas exposed to water leakage
This may cause electrocution or other damage including
malfunction.
- Areas exposed to static electricity
This may cause damage including malfunction.
- Areas exposed to excessive vibration
This may cause injury, malfunction, damage or loss of
proper electrical contact.
- Areas that are not flat or level
This may cause the Unit to fall and result in injury and/or
damage.
- Areas exposed to fire or overheating
This may cause damage including malfunction and
deformation.
- Areas exposed to excessive dust and dirt
This may cause damage including malfunction.
4

Before Using this Product

Important Notes about the Installation Procedure
(for using USB communication)
In order to use a USB connection to communicate between the Unit
and a computer, it is necessary to install the software and the USB
device driver.
Before connecting the Unit to a computer with a USB communica-
tion cable, it is necessary to fi rst install the software and the USB
device driver. If you connect the Unit to the computer before
installing them, the USB device driver may not be installed properly.
If you have connected the Unit to your computer before installing
the USB device driver, make sure to click the [Cancel] button in the
Wizard window when it pops up on the computer display. Then
disconnect the USB communication cable from the Unit.
For more details about the proper installation procedure, see the
Software User's Manual that accompanies "T&D Recorder for
Windows".
5