Additional Features: Removable Shelves
Shelves
Removable Shelf (Model 2054F only)
To remove the shelf, simply lift it up and tilt it on a sufficient angle to provide
clearance for removal.
Adjustable & Removable Shelves (Model 2084F)
These models are designed with 5 position adjustable shelves to allow greater
flexibility and further accommodate your particular security storage needs.
To Install:
Your Shelf and Shelf Support Clips have been
shipped inside your safe and wrapped for protection
from damage during shipping.
1. Remove Shelf and (4) Shelf Support Clips
from protective wrapping.
2. Determine the desired position of your shelf
and note the corresponding Support Guide
Slots (2 on each side of interior walls) that
are best suited to support the shelf in that
position.
3. Install the (4) Shelf Support Clips in the same
position on all four support guides.
4. Install shelf into position by placing it inside
the safe (tilting if necessary) at a point above
the desired position.
5. Once inside, lower it into position until
resting on Shelf Support Clips.
To change the position of the shelf:
Simply remove the shelf and reposition the (4) shelf
support clips by sliding them up and out of the
support slots and reinstalling them into the new
positions. Then reinstall shelf as described above.
Important: REMOVING SHELF
If you remove the shelf, it is strongly recommended that you DO NOT
DISCARD it. You may lay the shelf flat in the bottom of the safe to assure
full flexibility in the future.
Home and Office Security Safes
SUPPORT
GUIDES
3