Breville AquaStation LWA200BSS Instruction Book page 18

NOTE
This appliance is not calibrated for commercial
or scientific use. Temperatures may vary
by +/-2°C, which is within range for optimal
brewing for each tea menu. Hot temperatures
are indicative of temperature at the heating
element, not at the spout or in the cup.
NOTE
The appliance is calibrated at sea level hot
water temperatures. High altitude locations
will have an impact on hot water temperatures
due to low atmospheric pressure.
Hot Menu - Custom
This setting allows for customising of temp
and volume to suit any hot beverages.
1. Press the HOT water button once; the red
light ring will illuminate with the indicator
beside the first pre-set option on the hot
beverage menu, and the default temp and
volume will appear on the LCD screen.
NOTE
The water droplet white light will flash until
START/STOP is pressed to start dispensing.
2. Turn the FUNCTION dial until the
indicator on the LCD screen reaches
CUSTOM. Press the dial to confirm
selection.
3. When the TEMP digits on the LCD screen
begin to flash, rotate the FUNCTION dial
clockwise or anticlockwise to adjust the
temperature between 45-100°C. Press the
dial to confirm the selection.
4. When the Volume digits on the LCD screen
begin to flash, rotate the FUNCTION dial
clockwise or anticlockwise to adjust the
volume between 45-100°C. Press the dial to
confirm the selection.
18
5. Press START/STOP button once to start
dispensing the filtered hot water at the
customised temperature and volume. The
red light around the HOT button will be
remain on, the selected menu option and
the word HOT will flash on the LCD screen.
The water droplet white light will illuminate
solid while water is dispensing.
6. Water will automatically stop dispensing
once the set volume has been reached. The
red light around the HOT button and the
water droplet light will both turn off. The
purifier will return to standby mode.
NOTE
• The purifier will return to the last custom
setting used.
• To change your CUSTOM setting at any
time, repeat steps 1 -4 above.
• If the purifier is disconnected from the power,
the CUSTOM memory will reset to default.