Getting Started; Power On/Power Off - FlyTech M276 Quick Start Manual

Getting Started

1. Power-on / Power-off
Press the power button for 2 seconds to turn
on the system and press it for 6 seconds to
turn off the system.
NOTE: For best touch performance, remove
the protective plastic overlay from the touch
screen by peeling it away from one of the
corners. Be sure to use a soft pointing
device or finger tip to avoid scratching the
screen during normal use.
2. Installing the Peripheral Kits
Remove the dummy cover first.
Remove the rubber pads (x2) and screws (x2)
to release the top cover of the MSR module.
Connect the cable to the connector on the
system side. Then position the MSR module
over the system as shown and fasten with
the screws (x2). Finally place the top cover
of the MSR module back.
NOTE: The variety of peripheral kits like RFID/Fingerprint
and iButton all follow the same installation method.
4