Advertisement
Advertisement
Table of Contents
Related Manuals for LEDX Mamba 4 000 X-pand
Summary of Contents for LEDX Mamba 4 000 X-pand
- Page 1 Mamba 4 000 X-pand English...
- Page 2 Congratulations on your choice of LEDX headlamp The lamp has been developed with a focus on bright light, low weight and several different fields of use. Be careful; the light is very powerful, do not look straight into the lamp when tur- ning on the light.
- Page 3 The lamp case Connect the ba>ery to the lamp case. Be careful to fit the white markings on the con- tacts to each other; if they are incorrectly fi>ed and forced together the contact pins might break. Right Wrong The switch is placed at the bo>om of the lamp case. Light the lamp by pressing the switch unDl the lamp turns on (1-3s).
- Page 4 is water resistant but should not be immersed in water. At delivery, the ba>ery is partly charged, it must therefore be charged before using the lamp. Make sure you use the correct charger when charging the ba>ery.! The back up-baDery is a Li-Pol ba>ery with high capacity and low self-discharge. It is placed in the ba>ery holder on the back of the head gear.
- Page 5 The main ba>ery is charged with the larger charger and takes about 4 hours to charge fully. Do not discharge the ba>ery before recharging. The backup ba>ery is charged with the li>le charger and takes about 3 hours to re- charge.
- Page 6 Headgear The headgear is controlled by Velcro and can easily be adjusted. It also comes with mulDple figng points for the cable from the lamp case and its plug, and for the cable from the main ba>ery that is threaded through a loop before it connects to the lamp case.
- Page 7 Specifikation: Lamp housing with 4 LED Cree XM-L2, light system X-pand Weight: Lamp housing 76 g! Lamp housing with the headgear of 123 g! Lamp housing with headgear and back-up ba>ery 178 g! Lamp housing with headgear and back ba>ery 490g! The back ba>ery with cable 312 g! Backup ba>ery 35 g Operating times:!
- Page 8 The warranty is only valid if LEDX motorcycle cable is used when the lamp is connec- ted to any other ba>ery than a LEDX ba>ery. The ba>ery must not have a higher ra- ted voltage than 12 V...
Need help?
Do you have a question about the Mamba 4 000 X-pand and is the answer not in the manual?
Questions and answers