Advertisement
Available languages
Available languages
Table of Contents
Figure 1
Figure 2
Installation of Support Feet
In the support feet installation kit supplied in the product package, there are 4 pieces of
support feet, 4 pieces of screw and 4 pieces of washer. Screw the support feet on the product
without the washers as shown in Figure 1. Then place the product on the workbench where it
is to be installed and check whether it stands still or not. Depending on the planarity of the
workbench, in case one of the support feet do not touch on the workbench, use the washers
given in the installation kit as many as required, as shown in Figure 2.
52168492
Advertisement
Table of Contents
Subscribe to Our Youtube Channel
Related Manuals for ETNA KGV158WIT
Summary of Contents for ETNA KGV158WIT
- Page 1 Figure 1 Figure 2 Installation of Support Feet In the support feet installation kit supplied in the product package, there are 4 pieces of support feet, 4 pieces of screw and 4 pieces of washer. Screw the support feet on the product without the washers as shown in Figure 1.
- Page 2 Figuur 1 Figuur 2 Installatie van de kunststof steunvoetjes. In dit zakje zijn meegeleverd: 4 stuks steunvoetjes, 4 stuks schroeven en 4 stuks stelringen. Schroef de steunvoeten aan het product zonder de stelringen zoals getoond in figuur 1. Plaats de kookplaat op de tafel waar deze moet worden geïnstalleerd en controleer of deze vlak staat.
Need help?
Do you have a question about the KGV158WIT and is the answer not in the manual?
Questions and answers