Energy Saving Tips - AEG 66000I Operating And Installation Instructions

Clean the appliance and the interior accessories with a cloth and
lukewarm water. Commercially available dish washing detergents may
also be used.
After cleaning wipe with fresh water and rub dry.
An accumulation of dust will affect the performance of the appliance
and cause excessive electricity
consumption. The structure of the
appliance permits you to clean the rear
zone close to the wall, using a vacuum
cleaner.
Remove the plinth (1), then the venti-
lation grid (2);
Carefully pull the air deflector out (3),
checking that there is no water left
from the defrosting.
Check the water drain hole (F) under
the vegetable drawers of the fridge is
not blocked. Clear a blocked drain hole
with the aid of the green peg (P) in the
pack of accessories included with the
appliance.
After everything is dry place appliance
back into service.

Energy Saving Tips

• Do not install the appliance near boilers, radiators or other sources
of heat. High ambient temperatures cause longer, more frequent
operation of the compressor.
• Ensure sufficient air circulation and exhaust at the appliance base
and at the back wall of the appliance. Never cover air vent
openings.
• Do not place warm foods into the appliance. Allow warm foods to
cool first.
• Do not leave the door open any longer than necessary.
• Do not set temperature any colder than necessary.
• Put frozen food in the fridge to defrost. The cold in the frozen food
will then be used to cool the fridge.
22
2 1
3
P F