Table of Contents
Advertisement
Quick Links
Congratulations on your purchase of our Multifunctional Scale.
In order to ensure the scale continues to deliver peak performance, please
read these operation instructions carefully and thoroughly prior to initial usage.
1. Read all instructions before operating the scale.
2. Follow the basic safety precautions for all office equipment when using this
scale.
3. The manufacturer does not warrant this unit to be waterproof. Do not
expose this product to rain or moisture.
4. Do not use the scale in direct sunlight. Keep it away from heating
appliances such as an oven, stove, etc.
5. This scale does not contain any user-serviceable parts. Do not
disassemble.
5. Use the scale for its intended purpose only.
Note: The display value may be affected by electromagnetic influences, e.g.
when a radio is operated in the immediate vicinity of the device. The product
can be used for its intended purpose again when the interference is
discontinued, but may need to be switched on again to re-start.
DIGITAL COUNTING SCALE
M - Series
OPERATING MANUAL
INTRODUCTION
IMPORTANT
Advertisement
Table of Contents
Related Manuals for Escali M-Series
Summary of Contents for Escali M-Series
- Page 1 3. The manufacturer does not warrant this unit to be waterproof. Do not expose this product to rain or moisture. 4. Do not use the scale in direct sunlight. Keep it away from heating appliances such as an oven, stove, etc.
-
Page 2: Battery Installation
BATTERY INSTALLATION 1. Turn the entire scale upside down and reset it securely on a firm, flat surface. 2. Open the battery door by loosing the battery door screw. 3. Install four UM2 size C batteries in the battery compartment, ensuring that the positive/negative side is in the direction as shown in the cabinet. -
Page 3: Weighing An Item
LEVEL THE SCALE When the scale is put to use at a new place, adjust the level of the scale by turning the 4 level adjusting feet until the bubble is located in the middle position of the bubble leveler. -
Page 4: Power Off
Press “PCS” key to confirm the sample size. “pcs” icon will be shown on the left hand corner of the display. Press “PCS” again to return to weighing mode. Remark: the sample weight is memorized in the scale. You only need to repeat steps (2),(4) and (5) for different objects or sample size B. COUNTING:...
Need help?
Do you have a question about the M-Series and is the answer not in the manual?
Questions and answers