Extension Cords - Flex FX5141 Operator's Manual

EXTENSION CORDS

Extension cord plug should fit inside
•
tripod power bay. Some plugs may be
incompatible (Refer to Fig. a)
Fig. a
YES
Double insulated tools can use either a two
•
wire extension cord. As the distance from
the supply outlet increases, you must use a
heavier gauge extension cord. Using extension
cords with inadequately sized wire causes a
serious drop in voltage, resulting in loss of
power and possible tool damage. Be sure to
use an extension cord that has the capacity to
handle the current the product will draw. Refer
to the table shown to determine the required
minimum wire size.
Recommended Min. Wire Gauge for Extension Cords*
AMPERES RATING
0-2.0
2.1-3.4
3.5-5.0
5.1-7.0
7.1-12.0
12.1-16.0
NO
TOTAL LENGTH OF CORD IN FEET
25ft.
16
16
16
16
14
14
This product should be connected to a power
•
supply that is 120V AC, 60 Hz only (normal
household current). Do not operate this
product on direct current (DC) through the
power cord.
SJOW/SJTW/SOW/STW power cord can be
•
used, the cord length is at least 1.8m.
If you are using an extension cord outdoors,
•
be sure it is marked with the suffix "W-A" ("W"
in Canada) to indicate that it is acceptable for
outdoor use.
Be sure your extension cord is properly wired
•
and in good electrical condition. Always
replace a damaged extension cord or have it
repaired by a qualified person before using it.
Protect your extension cords from sharp
•
objects, excessive heat and damp or wet
areas.
Unplug all cords during lightning storms or
•
when unused for long periods of time.
50ft.
AWG
16
16
16
14
14
12
-5-
100ft.
16
14
14
12
10
NOT RECOMMENDED
Meet UL817