Table of Contents
Advertisement
Installation
Wall mounting
Loosen the security screw and remove the
AD32 card reader from the mullion mount.
Using the mullion mount as your template,
mark and drill two holes. Depending on your
mounting surface you may need to drill pilot
holes. If required, insert wall anchors now. Drill
1/2 inch (12.7mm) hole into the wall for cable
routing if necessary.
Route building-side cable through the circular
opening in the mullion mount and secure the
mullion mount to the wall using 2 provided wall
mount screws.
Connect the wires using the table above or on
the back of the AD32 module as reference.
Insert the AD32 module into the mullion mount
and secure using the T8 security screw and
Allen key (provided).
8
Verkada Inc. 405 E 4th Ave, San Mateo, CA 94401
sales@verkada.com
All specifications are subject to change without notice
Copyright © Verkada Inc. All rights reserved.
Advertisement
Table of Contents
