Download Print this page

Warnings And Cautions - Wagener Fairburn Installation, Operation & Maintenance Instructions Manual

Advertisement

Part 2: Operation & Maintenance Instructions for
WAGENER Fairburn Cooker
Message to the Owner
Thank you for purchasing a New Zealand designed and made Wagener Fairburn Cooker.
With care and common sense your Wagener Fairburn will give you many years of trouble free service.
We recommend an annual safety check of flues, bricks, door seals, door catches, air controls and the like.
When your Fairburn is not in use please ensure that the air control is in the closed position. The air control
should always be in the fully open position before opening the fire box door for starting and refuelling.

WARNINGS AND CAUTIONS

1. WARNING: ANY MODIFICATION OF THE APPLIANCE THAT HAS NOT BEEN APPROVED IN
WRITING BY THE TESTING AUTHORITY IS CONSIDERED AS BREACHING AS/NZS 4013.
2. WARNING: DO NOT USE FLAMMABLE LIQUIDS OR AEROSOLS TO START OR REKINDLE THE FIRE.
3. WARNING: DO NOT USE FLAMMABLE LIQUIDS OR AEROSOLS IN THE VICINITY OF THIS
APPLIANCE AND CHECK FIREBOX AND OVEN FOR FOREIGN OBJECTS WHEN OPERATING.
4. WARNING: DO NOT STORE FUEL WITHIN HEATER INSTALLATION CLEARANCES.
5. WARNING: DO NOT OPERATE THIS APPLIANCE AS AN OPEN FIRE. IT IS NOT TESTED TO BE
USED IN THIS WAY AND WILL BE CONSIDERED AS BREACHING AS/NZS2918:2001.
6. CAUTION: OPEN AIR CONTROL AND OVEN BYPASS BEFORE OPENING FIRE BOX DOOR.
7. CAUTION: THIS APPLIANCE SHOULD NOT BE OPERATED WITH A CRACKED GLASS.
8. CAUTION: THIS APPLIANCE SHOULD BE MAINTAINED AND OPERATED AT ALL TIMES IN
ACCORDANCE WITH THESE INSTRUCTIONS.
9. CAUTION: THE USE OF TREATED WOOD AS A FUEL CAN BE HAZARDOUS TO THE
ENVIRONMENT AND DETRIMENTAL TO YOUR APPLIANCE.
Further Cautions & Over Firing
DO NOT run the Fairburn with the door ajar or open. This will cause over firing and damage to your stove
and flue which will NOT be covered by warranty as well as being potentially dangerous.
SIGNS OF OVER FIRING: Flue turns red hot, stove "roars", cooktop surface becomes red hot.
POSSIBLE CAUSE OF OVER FIRING
1. Excess flue length/windy conditions
2. Appliance run with door ajar
3. Worn or Faulty door seals
4. Full load of very dry, small wood
5. Dirty flue catches fire
The Fairburn is HOT while in operation and caution is required as contact may cause burns.
Keep children away and use appropriate tools and protective mitts when operating.
CREOSOTE OR SOOT FIRE: In the unlikely event of a soot or creosote fire occurring close air control
and bypass control and alert household occupants and ensure their safety. Then see Remedy 5 above.
REMEDY
Move air control to reduce or close air supply
Close the door
Replace door seals
Don't load excess quantities of fuel
Close air supply. Alert occupants and ensure their
safety. Call fire brigade if necessary. Inspect & Clean flue
when cold. Review quality and type of fuel being used.
6
2021

Advertisement

loading