Playing The Radio; Using The Flashlight - Emerson RP6289 Owner's Manual

Am/fm radio/flashlight battery operation and back-up dynamo power supply
Table of Contents

Advertisement

OPERATING INSTRUCTIONS

PLAYING THE RADIO

1.) If you have installed "AA" batteries, set the DYNAMO/BATT selector switch
to BATT position. To power the radio using the rechargeable pack or the
generator, set the DYNAMO/BATT selector switch to DYNAMO position.
2.) Rotate the VOLUME control clockwise ( ) to turn the radio "On".
3.) Set FM/AM band selector to the desired band. If you selected the FM band,
extend the FM rod antenna to its full length.
4.) Rotate TUNING control to select the desired station.
5.) Adjust VOLUME control to a comfortable listening level.
6.) To turn off the radio, rotate the VOLUME control fully counterclockwise (
USING EARPHONES/HEADPHONES
To listen to the radio privately, connect an earphone or
headphone (not including) with a 3.5-mm (1/8-inch) plug
to the jack beneath the rubber flap on the side of the
radio. Plugging in an earphone or headphone
disconnects the internal speaker.

USING THE FLASHLIGHT

Slide the HI/OFF/LO switch on the top of the unit to the
HI or LO position to turn the light "On".
Slide the HI/OFF/LO switch to OFF to shut the light "Off".
Note: The operating time of the flashlight will be longer when the light switch is
set to the "LO" position.
RP6289_030504.p65
LIGHT
OFF
HI
LO
8
8
5/3/2004, 11:02
).

Advertisement

Table of Contents
loading

Table of Contents