Advertisement
Control Panel Extension Cord
E3000 - PEX4
OPERATION MANUAL
Thank you for purchasing control panel extension cord E3000-PEX4. This control panel extension cord is designed
for can be away placed from the E3000 CONTROLLER or SELECTOR main body.
Read this and E3000 CONTROLLER or SELECTOR Operation Manual carefully before use.
1 . SPECIFICATIONS AND DIMENSIONS
Model
E3000-PEX4
Applicable Unit
E3000 CONTROLLER, E3000 SELECTOR
Front Panel Dimensions
73mm × 73mm
Attachable Pitch
63mm × 63mm
Attachable Hole Dimensions
φ 3.4mm
Cord Length
4m
Standard Accessories
・ Mounting Screw・・4pcs.
・ Operation Manual・・1set.
2 . INSTALLATION OF THE CONTROL PANEL EXTENSION CORD
WARNING
Turn OFF the Main Power Switch of CONTROLLER or SELECTOR, and pull OFF the Plug of
①
the Power Cord from Inlet box with Power Supply Fuses before Control Panel Extension Cord
mounting.
When attaching the Control Panel of CONTROLLER or SELECTOR, make sure that no oil or
②
other contaminants are on the mounting surface.
Take care when selecting routing of Cord of Control Panel of the CONTROLLER or SELECTOR
③
to insure that the Cord is not routed rear potential sources of RF noise.
④
Attach the Control panel of CONTROLLER or SELECTOR in manner to insure that the back of
the circuit board of the Control panel of the CONTROLLER or SELECTOR does not contact any
object or surface that could cause potential short circuits.
CAUTION
①
It is capable to use the Control Panel Extension Cord both for CONTROLLER and SELECTOR.
②
When attaching the Control Panel Extension Cord, please use the Control Panel of E3000
CONTROLLER or E3000 SELECTOR. For E3000 CONTROLLER, use the Control Panel of the
E3000 CONTROLLER. For E3000 SELECTOR, use the Control Panel of the E3000 SELECTOR.
This Operation Manual can be used both for CONTROLLER and SELECTOR. When attaching Control Panel
Extension Cord to CONTROLLER and SELECTOR, please this Operation Manual carefully before use.
① Remove the Control Panel Mounting Screw (4pcs.) and remove the Control Panel to front.
*Inset for E3000 CONTROLLER
② Remove the connector of the rear of the Control Panel (Fig. 2) and remove the Control Panel (Fig. 3).
Connector
Fig. 2
・ Flange Nut・・4pcs.
Control Panel
Mounting Screw
Control Panel
Fig. 1
Fig. 3
③ Connect the connector of Front Panel of the Control Panel Extension Cord to the connector of the
CONTROLLER or SELECTOR (Fig. 4).
Attach the Front Panel of the Control Panel Extension Cord to CONTROLLER or SELECTOR by mounting
screw (Standard Accessories). (Fig. 5)
Fig. 4
④ Connect the connector of the Control Panel Extension Cord to the connector of the Control Panel.
Control Panel
⑤ Fasten the Control Panel for CONTROLLER or SELECTOR to your ordered box by using the Control Panel
Mounting Screw removed in ① .
Front Panel
Connector
Fig. 5
Connector
Fig. 6
Fig. 7
2017 . 07 . 31 002
Advertisement
