Table of Contents
Advertisement
UNPACKING AND SET UP
• Carefully remove the unit from the carton and remove all the packing material
from the unit.
• Carefully remove any small strips of tape which may have been used to keep
the CD/Cassette door closed during shipment.
• Open the CD/cassette compartment by lifting the PULL OPEN tab at front of top
cover. Inside the CD compartment you will see a white transit card which is
used to prevent the laser pick-up from moving during shipment. Carefully remove
this card and close the CD/cassette door.
• Please save the carton and packing materials in the event that your unit ever
needs to be returned for service. The original carton and packing materials are
the only way to protect the unit from damage during shipment.
• The AC power cord is inside the polyfoam packing material. Make sure that you
do not accidentally discard the AC cord with the packing material.
PROTECT YOUR FURNITURE
This model is equipped with non-skid rubber 'feet' to prevent the product from
moving when you operate the controls. These 'feet' are made from non-migrating
rubber material specially formulated to avoid leaving any marks or stains on your
furniture. However certain types of oil based furniture polishes, wood preservatives,
or cleaning sprays may cause the rubber 'feet' to soften, and leave marks or a
rubber residue on the furniture. To prevent any damage to your furniture we strongly
recommend that you purchase small self-adhesive felt pads, available at hardware
stores and home improvement centers everywhere, and apply these pads to the
bottom of the rubber 'feet' before you place the product on fine wooden furniture.
POWER SOURCES
This unit is designed to operate on 8 "D" batteries, not included, or on normal 120V
60Hz AC house current. Operating this unit from any other power source may
cause damage to the unit, and such damage is not covered by your warranty.
PD3500RD_102904.p65
PREPARATION FOR USE
4
4
29/10/2004, 15:36
Advertisement
Table of Contents
