Advertisement
General Instructions for Use
Operation
WARNING! TO PREVENT SERIOUS INJURY: Release
trigger if tools shut down. Press Trigger again to restart.
1. Make sure Trigger is in off-position,
then attach Battery Pack.
2. Place a bucket (not included) on a flat, level surface.
NOTE: Refer to the material manufacturer's
instructions for proper mixing instructions.
3. Pour the material into the bucket.
4. Set Gear and Speed.
Cleaning
1. Immediately after use, clean the Mixing Paddle.
a. If material is water-based, fill clean
bucket with water, put Mixing Paddle
into bucket and squeeze Trigger.
b. If material is oil-based, wipe off Mixing Paddle
with a clean towel, then wipe off with a clean
cloth moistened with mineral spirits.
Item 58152
For technical questions, please call 1-888-866-5797.
5. Hold onto grips of both Handles
without engaging Trigger.
6. Put Mixing Paddle into bucket.
7. Push Lock-off Button, then squeeze
trigger to start tool.
Note: Tool will not start unless Lock-off Button
is pressed before squeezing Trigger. Do not
overload tool. If tool bogs down, release Trigger.
8. When material has been mixed, release Trigger.
Wait for tool to come to a complete stop and
remove Mixing Paddle from material.
2. Dry the Mixing Paddle with a clean cloth.
3. To prevent accidents, turn off the tool and
remove its Battery Pack after use.
4. Spray the paddle with light oil to prevent
rust while in storage, then store the tool
indoors out of children's reach.
Page 11
Advertisement
