Table of Contents
Advertisement
NL Troubleshooting
Malfunction
Door cannot be
opened.
Washing water is not
pumped out.
42
Cause and Troubleshooting
is activated.
Resume the program by Centrifuge / Essorage or
▶
Drain to choose and press Start/Pause to push.
→ "Resume program at rinse hold", page 34
Temperature is too high.
Wait for the temperature to drop.
▶
→ "program cancel", Page 33
▶
Water level is too high.
Select a suitable program for draining.
▶
→ "Programs", Page 26
Power cut.
Open the door with the emergency release.
▶
→ "Emergency release", page 48
Drain pipe or water drain hose is clogged.
Clean the drain pipe and the water drain hose.
▶
Drain pipe or water drain hose is kinked or
pinched.
Make sure that the drain pipe and the water
▶
drain hose are not kinked or pinched.
Drain pump is clogged.
→
"Cleaning the drain pump", page 36
▶
is activated.
Resume the program by Centrifuge / Essorage or
▶
Drain to choose and press Start/Pause to push.
→ "Resume program at rinse hold", page 34
Water drain hose is connected too high.
Install the water drain hose at a maximum height of 1
▶
meter.
Pump cover not assembled correctly.
Assemble the pump cover correctly.
▶
Detergent dosage is too high.
▶ Immediate measure: mix a tablespoon of fabric softener
with 0.5 l of water and pour this mixture into the left
compartment (not for outdoor, sportswear and down
textiles).
Reduce the amount of detergent for the next wash
▶
with an equal load.
Advertisement
Table of Contents
