Advertisement
NOTE: Not all steps may apply for all installations.
WARNING - To reduce the risk of severe injury or death.
1. READ AND FOLLOW ALL INSTALLATION INSTRUCTIONS.
2. Install only on a properly balanced garage door or gate. An improperly balanced door has the potential to inflict severe injury. Have
a qualified service person make repairs to cables, spring assemblies, and other hardware before installing the opener.
3. Remove all ropes and remove or make inoperative all locks connected to the garage door or gate before installing opener.
4. Where possible, install the door opener 7 feet or more above the floor. For products having an emergency release, mount the
emergency release within reach, but at least 6 feet above the floor and avoiding contact with vehicles to avoid accidental release.
5. Do not connect the opener to source of power until instructed to do so.
6. Locate the control button: (a) within sight of door, (b) at a minimum height of 5 feet so small children are not able to reach it, and (c)
away from all moving parts of the door.
7. Install the Entrapment Warning Label next to the control button in a prominent location. Install the Emergency Release Marking.
Attach the marking on or next to the emergency release.
8. After installing the opener, the door or gate must reverse when it contacts a 1-½ inch high object (or a 2 x 4 board laid flat) on the
floor.
WARRANTY
The warranty period of this product is 24 months, beginning from the manufacturing date. During this period, if the product does not
operate correctly, due to a defective component, the product will be repaired or replaced at the sole discretion of Transmitter
Solutions. This warranty does not extend to the product casing which can be damaged by conditions outside of the control of
Transmitter Solutions.
iGAZESO35 Solar Powered Photo Eyes
are compliant with the specifications of Directive EMC 2004/108/EC.
Advertisement
