Eiki LC-SX3 Owner's Instruction Manual page 16

CONNECTING THE PROJECTOR
CONNECTING AN IBM-COMPATIBLE DESKTOP COMPUTER
NOTE:
Before using with digital connection, install (Plug in) Graphic Accelerator Board (included within projector) into PCI
bus slot of the computer and set up the computer following instructions in the Graphic Accelerator Board package.
COMPUTER
SERIAL PORT PS/2 PORT
INPUT
INPUT
MOUSE CABLE FOR
PS/2 PORT
(PROVIDED)
MOUSE CABLE FOR
SERIAL PORT
(PROVIDED)
SERIAL PORT CABLE
(NOT PROVIDED)
AUDIO
INPUT
L
NOTE: When connecting the cable, the power cords of both the projector and the external equipment should be
disconnected from AC outlet. Turn the projector and peripheral equipment on before the computer is switched on.
16
(DIGITAL INPUT CONNECTION)
GRAPHIC
ACCELERATOR
BOARD
INSTALL (PLUG)
INTO PCI BUS SLOT
R
COMPUTER
AUDIO OUTPUT
L
COMPUTER
AUDIO INPUT 1
CONTROL PORT
OUTPUT 1
AUDIO CABLE
(NOT PROVIDED)
SPEAKER
OUT
R
L
R
Amp.
MONITOR CABLE
(NOT PROVIDED)
ANALOG
OUTPUT
DIGITAL
OUTPUT
AUDIO CABLE
(NOT PROVIDED)
R L
USB 1 CONTROL PORT 1 AUDIO 1
R L
(MONO)
USB 2 CONTROL PORT 2 AUDIO 2
R L
(MONO)
AUDIO OUT
R/C JACK SERIAL PORT
R L
SERIAL
PORT
OUTPUT
COMPUTER
AUDIO OUTPUT
Speaker (L)
DIGITAL FLAT
PANEL CABLE
(PROVIDED)
COMPUTER
INPUT 1
(DIGITAL)
ANALOG DIGITAL
R G B H V
ANALOG RGB
Speaker (R)