Copal PG-100 Instruction Manual

HANDY MANOMETER
PG-100
（Compliance with EMC Standards）
INSTRUCTION MANUAL
1. HANDLING NOTES
§
CAUTION
CAUTION
The each attachment fitting torque to the pressure port should be less than 1 N・m.
Availabie media to be measured is air or non corrosive gas only.
The another media ,i.e. water or corrosive gas/liquid may damage the internal structure and cause malfunction.
Applied pressure must be less than the specified maximum pressure.
Internal battery
Replace battery with Toshiba Battery Co.,Ltd. /ERVM3.6V/ lithium battery only. Use of another battery may present a risk of fire or explosion. If you need
replace battery, please place an order with us.
When LOBAT sign is displayed, the battery should be replaced.
The battery used in this device may present risk of fire of chemical burn if mistreated. Do not recharge, disassemble, heat above 100℃(212° F), or incinerate.
Dispose of used battery promptly. Keep away from children. Do not disassemble and do not dispose of in fire.
The only pH neutral detergents should be used to clean the body.
The solvents such as thinners, benzine, etc. must be not used.
2. TRANSPORTATION & STORAGE
§
The product,which is a precision instrument, must be taken special care not to be damaged by impact nor by being dropped when it is trasported and in storage.
The product must be avoided in storage where is dusty, dripping and vibrated.
Thank you very much for your purchase of our products.
This instruction manual is prepared for your proper use of
the product, which conforms to the EC Directive according
to the EMC Directive 89/336/EEC.
Ver.2.1
Nishi-Shinjuku Shinjuku-ku Tokyo 160-0023, Japan Phone. ： (03) 3364-7055
WARNING
This caution mark describes when there is a possibility that user may suffer from damage or physical
damage may occur if the product is used improperly.
For more detailed information please ask for the
nearest distributor or the following sales center.
Nishi-Shinjuku Kimuraya Bidg. , 7-5-25
1