Commissioning In 4 Steps; Connect / Disconnect The Remote Control / Wall Controller - DekoLight 843062 Manual

Product-Notes
Manual
Article No.: 843062 / 843063 / 843068 / 930657

10. Commissioning in 4 steps

1. Install the controller and connect the supply voltage (12 / 24V DC) and the LED strip
2. Select the required channel mode on the controller by pressing the „Switch" button (1-5 channel)
3. Insert the batteries in the remote control or the wall controller
4. Teach in the radio remote control / radio wall controller in the corresponding controller

11. Connect / disconnect the remote control / wall controller

Connecting
1. Switch off the power
supply of the controller for
at least 10 seconds
Caution! If the pairing was not successful, please start again from step 1.
Disconnect
1. Switch off the power
supply of the controller for
at least 10 seconds
Caution! If the separation was unsuccessful, please start again from step 1.
Deko-Light Elektronik-Vertriebs GmbH
www.deko-light.com / deko@deko-light.com
Technical Data can be changed without advance notice. Errors excepted.
2. Switch on the power
supply of the controller and
within 3 seconds. Press the
On button 3 times on the
desired zone
2. Switch on the power
supply of the controller and
within 3 seconds. Press the
On button 5 times on the
desired zone
3. The connected LED strip
must flash 3x to confirm
3. The connected LED strip
must flash 10x to confirm
26.11.2021
1 / 16