Related Manuals for Dual Electronics Corporation XDMA6438
Summary of Contents for Dual Electronics Corporation XDMA6438
- Page 1 XDMA6438 INSTALLATION/OWNER'S MANUAL AM/FM/CD Receiver with Detachable Face Front and Rear Inputs...
- Page 2 XDMA6438 INSTALLATION Preparation Please read entire manual before installation. Before You Start • Disconnect negative battery terminal. Consult a qualified technician for instructions. • Avoid installing the unit where it would be subject to high temperatures, such as from direct sunlight, or where it would be subject to dust, dirt or excessive vibration.
-
Page 3: Wiring Diagram
Connect a portable device Wiring Diagram FUSE When replacing the fuse, make sure new fuse is the correct type and amperage. Using an incorrect fuse could damage the radio. The XDMA6438 uses one 10 amp ATM fuse located beside the wiring connector. -
Page 4: Control Locations - Receiver
XDMA6438 OPERATION Control Locations - Receiver Power Release Equalizer Tune / Track Down Tune / Track Up Volume / Select (push) Mode Up Mode Down Mode Indicator Eject USB Port Auxiliary Input Preset 6 / Folder Up Preset 5 / Folder Down Preset 4 / Play / Pause... -
Page 5: Control Locations - Remote
Select / Power Tune / Track Up Volume Down Display Preset 3 / Intro Preset 2 / Random XDMA6438 OPERATION Preset 6 / Folder Up Loudness Mute Preset 5 / Folder Down Preset 4 / Play / Pause Preset 1 / Repeat... -
Page 6: General Operation
NOTE: CD, USB and operation of iPod modes will not appear unless a CD is inserted or USB/iPod devices are connected. The XDMA6438 offers two auxiliary input ports, a 3.5 mm port on the front panel and an RCA connection on the back of the unit. - Page 7 Dimmer DIMMER LOW DEMO OFF Demonstration Mode DEMO ON XDMA6438 OPERATION Press SELECT to seek and save 6 strong stations in the current band. (Tuner mode only) Activates distance tuning (Tuner mode only). Activates local tuning for strong station reception only (Tuner mode only). Programs the unit to USA tuner spacing.
- Page 8 XDMA6438 OPERATION General Operation Audio Press AUDIO momentarily to select between Bass, Treble, Balance, Fader, Subwoofer and Source Volume Level. BASS TREBLE BALANCE FADER SUBWOOFER* SOURCE LEVEL Bass Press AUDIO until BASS appears then rotate volume knob left/right to adjust ( -6 minimum / +6 maximum).
- Page 9 Seek Tuning Manual Tuning Band Storing and Recalling Station Presets XDMA6438 OPERATION AM/FM Tuner Operation Press TUNE or TUNE to seek to the next strong station. Press TUNE or TUNE radio frequency up or down one step at a time. Press and hold to advance quickly. Press BAND to select between FM1, FM2, FM3, AM1 and AM2 bands.
-
Page 10: Cd Player Operation
XDMA6438 OPERATION CD Player Operation Insert CD Eject CD Track Select Fast Forward and Reverse Pause Intro Repeat Random CD-R/CD-RW Compatibility With the label facing up, insert a standard size CD into the CD slot. The CD will automatically begin playback. Press EJECT to eject the CD. The unit will change to previous mode of operation. - Page 11 XDMA6438 OPERATION CD Player Operation - MP3/WMA Files Playing an MP3/WMA Disc When an MP3/WMA encoded disc is first inserted, “DISC READ” will appear in the display. Depending on the number of files and folders, this may take several seconds. Displaying Information Press DISP to select between song title, artist, file name, folder name, track number, and clock/elapsed time.
- Page 12 XDMA6438 OPERATION CD Player Operation - MP3/WMA Files Folder/File Search Mode Step 1 Step 2 Step 3 MP3/WMA CD mode features a file and folder search mode. This search allows navigating through folders to find a specific MP3 or WMA file for playback. Press SELECT to enter the file/folder search mode. A list of all the folders on the CD will be displayed.
- Page 13 • FOLDER - Plays first 10 seconds of each track in folder. Note: Folder repeat, random and intro options only function on MP3/WMA discs recorded with more than one folder. XDMA6438 OPERATION to select the previous folder. to select the next folder.
- Page 14 XDMA6438 OPERATION CD Player Operation - MP3/WMA Files Media Compatibility Playback Order Compatible Recording Formats The following types of discs/files are compatible: • CD-ROM (ISO), CD-R, CD-RW • CD-DA • MP3 data • WMA data The following types of discs/files are not compatible: • WMA files that are protected by DRM (Digital Rights Management).
- Page 15 Information Sampling Frequency Rates Transfer Bit rates MP3 Tag Display Recommended Settings XDMA6438 OPERATION An internal buffer provides ESP (Electronic Skip Protection) to virtually eliminate skipping. When playing a disc recorded with regular audio files (CD-DA or .WAV) and MP3/WMA files, the unit will play the MP3/WMA files only.
-
Page 16: Usb Operation
To play MP3/WMA files from most USB mass storage devices, line up the USB connector and insert the USB device into the XDMA6438's USB port. When a USB device is first connected, “USB READ” will appear in the display and playback will begin momentarily. - Page 17 Folder Access Repeat Random Intro XDMA6438 OPERATION When a file is accessed, the clock and elapsed time will be displayed. Press DISP momentarily to select beween song title, artist, file name, folder name, track number and clock/ elapsed time. "NO TITLE" will be displayed if no song title information is available.
- Page 18 XDMA6438 OPERATION USB Operation Character Support Maximum character display information • Track name – 32 character maximum • Directory name – 32 character maximum • *Song title – 32 character maximum • *Artist name – 32 character maximum *Song title and artist name will only be displayed if included with the MP3/WMA file.
- Page 19 Additional MP3/WMA Information Sampling Frequency Rates Transfer Bit rates MP3 Tag Display XDMA6438 OPERATION Only MP3 files with filename extension (.mp3) can be played. Only WMA files with filename extension (.wma) can be played. Do not attempt to play non-MP3/WMA files with the MP3/WMA extension. 8kHz ~ 48kHz...
-
Page 20: Operation Of Ipod
Menu Full/Manual Control The XDMA6438 features both full and manual control modes for iPod/iPhone devices. See page 7 for details to toggle the control between full and manual modes. Important: To support manual control for iPod/iPhone, the iPod device must be updated to the newest firmware using iTunes. - Page 21 • iPhone 3GS • iPhone 3G • iPhone *These devices are not compatible with manual control mode. XDMA6438 OPERATION Operation of iPod to skip to the beginning of next song. Press to return to the beginning of current song. Pressing again skips to the beginning of previous song.
-
Page 22: Limited One Year Warranty
XDMA6438 WARRANTY Limited One Year Warranty This warranty gives you specific legal rights. You may also have other rights which vary from state to state. Dual Electronics Corp. warrants this product to the original purchaser to be free from defects in material and workmanship for a period of one year from the date of the original purchase. -
Page 23: Troubleshooting
Unit will not accept a disc An invalid ID3 tag version is present NO SUPPORT appears on display An ID3 tag character is not supported XDMA6438 OPERATION Cause voltage Red wire not connected or incorrect voltage Black wire not connected Fuse blown Speaker wires not connected Yellow or red wire touching chassis... -
Page 24: Specifications
XDMA6438 OPERATION Specifications CD Player FM Tuner AM Tuner General Power Output: 18 Watts RMS x 4 channels at 4 ohms and < 1% THD+N Signal to Noise Ratio: 80dBA (reference: 1 watt into 4 ohms) Frequency response: 10Hz-20kHz Channel separation @ 1kHz: D/A converter: 1 Bit... -
Page 25: Fcc Compliance
Increase the separation between the equipment and receiver. • Connect the equipment into an outlet on a circuit different from that to which the receiver is connected. • Consult the dealer or an experienced radio/TV technician for help. XDMA6438 OPERATION FCC Compliance... - Page 26 XDMA6438 OPERATION Notes...
- Page 27 XDMA6438 OPERATION Notes...
- Page 28 Dual Electronics Corp. Toll Free: 1-866-382-5476 www.dualav.com ©2011 Dual Electronics Corp. All rights reserved. iPhone, iPod, iPod classic, iPod nano, and iPod touch are trademarks of Apple Inc., registered in the U.S. and other countries. “Made for iPod” and “Made for iPhone” mean that an electronic accessory has been designed to connect specifically to iPod or iPhone, respectively, and has been certified by the developer to meet Apple performance standards.
Need help?
Do you have a question about the XDMA6438 and is the answer not in the manual?
Questions and answers