TrueCut TrueSharp Instructions

Part List

• Sharpener
• Blade Remover
• Two Coarse Stones
• Cleaning Cloth
• Oil
• Power Supply
• Instructions
• Allen Wrench
* IMPORTANT:
Do not sharpen newly out-of-the package blades! The
TrueSharp is used to hone a dull blade to a near
factory-sharp edge. You will not be able to achieve a factory-polished edge.
Damage and nicks on blades caused by pins, etc. are sometimes irreparable.
Before using your sharpener for the first time, saturate the sharpening stones by dropping oil onto the
stone's surface until the oil no longer absorbs and begins to pool on the surface.
To saturate the upper stone, cup the lid of the sharpener in your hand by
tilting the sharpener back until the lid is parallel with the floor.
To use your sharpener,
1. Plug in your sharpener.
2. Open your sharpener and place a drop of oil on the sharpening
stones and then place a blade on the blade tray. Blades should
be centered in one of the slots.
3. Close the lid slowly, being careful not to knock the blade out of center.
The TrueSharp rotary sharpener is a safe, convenient and effective
way to extend the life of your rotary blades.
Lever
Latch
Sharpening
Stones
Blade Tray