Installation - Pyle 3017DX Owner's Manual

INSTALLATION

Here is the installation diagram.
NON PULL-OUT UNIT
Precautions
1. Choose the mounting location where the unit will
not interfere with the normal driving functions of
the driver.
2. Avoid installing the unit where it would be subject
to high temperature, such as from direct sunlight,
or from hot air, from the heater, or where it would
be subject to dust, dirt or excessive vibration.
3. For safe installation, use the mounting hardware
provided by the manufacturer.
REMOVE THE UNIT FROM THE DASH BOARD
1. Remove the detachable control panel.
2. Insert the supplied keys into the slot as shown, and slide the unit out of the dash board while
holding the trim plate.
3. Remove the metal strap attached to the back of the unit.
4. Remove the keys from the slot.
5. Disconnect all the wires of the unit and the antenna plug.
RELEASE KEYS
METAL MOUNTING STRAP
HEX BOLT
SLOTS
DASH BOARD
PLAIN WASHER
CONSOLE
MOUNTING HOUSING
Fire Wall
TRIM PLATE
2
HEX NUT
SPRING WASHER
TAPPING SCREW
Bracket
SLEEVE