Error Indications - Citizen CT-D101 User Manual

4.5 Error Indications

l Paper End
If the paper ends, the ERROR LED lights and a buzzer sounds. Load a new paper
roll. The buzzer may not sound depending on the memory switch setting.
l Cover Open
If the cover is opened, the ERROR LED lights and a buzzer sounds.
The buzzer may not sound depending on the memory switch setting.
Do not open the cover during printing. If the cover is accidentally opened, the
ERROR LED flashes. Check the paper, pull it straight out of the printer by a couple of
centimeters, and then close the cover. Printing restarts. A command must be sent to
restart printing depending on the memory switch setting.
l Cutter Error
If the auto cutter stops due to paper jamming, etc., the ERROR LED flashes. Remove
the cause and press the FEED key. If the auto cutter still does not move and the pa-
per cover cannot be opened, refer to "Clearing a Cutter Error."
l Print Head Hot
Dense printing, heavy black printing, and continuous printing in a high temperature
environment increase the temperature of the print head. When the print head ex-
ceeds a certain temperature, the printer stops printing and waits until the temperature
of the print head decreases. The ERROR LED flashes during this time. When the
temperature decreases, printing restarts automatically.
The status display for various messages is shown below.
Status
Paper End
Cover open*1
Cover open II*2
Cutter Error
Memory Error
Print Head Hot
Low-voltage Error
High-voltage Error
System Error
Wait for Macro Execution
POWER LED (green)
Lit
Lit
Lit
Lit
Lit
Lit
Lit
Lit
– 46 –
Refer to 4.2 Clearing a Cutter Error
ERROR LED (red)
Lit
Lit
-
Unlit
Buzzer sound *3
Yes
Yes
Yes
Yes
No
No
No
No
No
No