InCarTec 29-UC050-SAAB Quick Start Manual

29-UC050-SAAB
For
SAAB 9-3 and 9-5 2006 on
Vol +, Vol-, Seek +, Seek - only
1– Connect the cables to the box and to the car and the PATCH LEAD to the 4 pole black
connector (this is attached to pins 4,8&12 of the control box). Connect the two 8 way ISO
connectors and the patch lead to the aftermarket head-unit.
When connected to the car the interface will automatically recognise the vehicle. The green LED
on the interface will repeatedly flash once followed by a pause.
2-You need to set the interface to the brand of head unit you are fitting.
The amount of flashes between pauses corresponds to the make of head unit, see the table
below for the number of flashes needed for each one.
Press the VOL + and VOL- buttons on the cars steering wheel to increase or decrease the
amount of flashes. When you have the correct amount of flashes, press SEEK+ to confirm and
the LED will go to a solid green
Number Make of head unit
of flashes
1 Clarion 3.5mm jack
2 Kenwood 1 wire
3 JVC 1 wire
4 Alpine 3.5mm
6 Pioneer 3.5mm jack
Chinese 2 wire
Chinese 3.5mm jack
7 Sony 3.5mm jack
UNICAN SWC INTERFACE
For Chinese self learning head-units.
Set the number of flashes to 6. Confirm the setting by pressing
SEEK +. Now press the reset button 5 times, the interface will
start to flash red and green ( this allows prolonged pressure
on the steering controls ). Using the radios resistive learning
menu you can now learn and memorize the buttons. Wait at
least 5 seconds between each button press. When finished
turn the ignition off and on and the LED will go back to solid
green
To reprogram the interface for another head unit brand
or if the light is solid green before you have had the
chance to set the head-unit brand.
Push the reset button in and keep it pushed in for 10
seconds and then release the button. At this point the LED
should start to flash green.
Setting the J1 jumper (only for Alpine units)
There are a series of jumper pins on the interface board.
The normal default J1 is between 2-3 (as shown on the left) . If you are
fitting an Alpine unit this jumper needs to be moved to jumpers 1-2 ( see
over for example)
1 2 3
8 9 10
2 Green = GM LAN BUS input
3 Orange = Illumination output
4 Brown = SWC DATA output
5 Red = 12V ACC ignition output
7 Yellow = 12V +30 Battery input
8 Black = SWC GROUND output
10 Blue = Reverse signal +12Voutput
11 Grey = Speed pulse output
12 Purple = SWC RES output
14 Black = Ground input
4 5 6 7
11 12 13 14