Out Of Range Notification; System Maintenance; Low Battery Indicator - Directed Electronics 580 Owner's Manual

Directed electronics 580 remote start keyless entry owner's guide

Hide thumbs Also See for 580:

Table of Contents

➤ Out of range notification

If a command is issued from the remote, but the remote is beyond the range

of the vehicle to receive the command, the remote will respond with an out-of

range notification. If this occurs, the transmit indicator on the remote flashes

rapidly, the

key LED turns on, and the remote emits the error tone sounds.

Since conditions will vary in different areas (i.e.: Weather, RF interference, etc)

range may be affected and require you to be closer to the vehicle for successful

transmission.

The system requires no specific maintenance. Your remotes are powered by

small coin cell lightweight 3-volt lithium batteries that last approximately one

year under normal use. The 2-way remote uses two CR2016 cell batteries and

the 1-way remote uses one CR2032 cell battery. When the battery begins to

weaken, the operating range is reduced.

When the batteries are low on the 2-way remote it emits two groups of beeps,

the

LED flashes, and the system emits an additional honk when unlocking to let

you know its time to change the battery. When the battery is low on the 1-way

remote, the remote responds the same, but without the LED flash.

Note: The Lock/Unlock confirmations should be programmed On,and the op-

tional horn honk installed, for the system to emit any additional honks during

unlocking. Ask your authorized dealer if you have any questions.

Table of Contents

Do you have a question about the 580 and is the answer not in the manual?