Nedap the PowerRouter Installation Manual page 17

grid-related error codes
Error code on display Error cause
D001-S Grid module temperature too high
D002-S An internal bus problem
D003-S
D007-S Grid relay failure
D007-h
D010-S Internal overload
D015-S Internal communication error
D025-h An internal bus problem
D027-h
D028-h Internal supply voltages out of range
D029-S Cold start failed
D011-S Load voltage too low
D012-S Load voltage too high
D013-h Load short circuit
D023-h Current overload
D031-h Power overload
System-related error codes
Error code on display Error cause
P027-h Internal voltage error
P028-h Internal frequency error
P029-h Internal relay error
P089-h Self-use sensor not found
P092-h The PowerRouter is not configured
P098-h hardware is not supported in software
P081-h Install wizard error
User recommended action
Check ambient temperature of the PowerRouter. Check for
obstructions in the air flow channel.
Contact your installer/dealer if this fault occurs frequently
Check grid voltage
Check load
Disconnect excessive loads
User recommended action
Contact your installer/dealer if this fault occurs frequently
Reset the PowerRouter, re-run the Install Wizard
EN
17