GE UPK4 Installation Instructions Manual page 2

INSTALLING PUMP KIT
DISCONNECT ELECTRICAL POWER
WARNING
Death or serious injury can result from failure to
follow these instructions.
• Service by a qualified service technician only.
• Disconnect power before servicing this product.
• Reconnect all grounding devices after service.
• Replace all parts and panels before operating.
1
REMOVE SIDE PANEL
Use a drill or a Phillips screwdriver to remove the
2 screws from the access panel as shown in figure
below. Slide the panel in the direction shown to
remove.
2
Installation Instructions
Electrical Shock Hazard
Screws
Access
Panel
Slide panel in
this direction
(Cont.)
2
REMOVE DRAIN TUBING
Remove the plastic snap ring from the white drain
pipe. Move the ring sides up and down as shown
to unlock and remove. Save this ring.
Remove the white drain pipe by pulling it down
from the 2 locations shown.
3
INSTALL RUBBER PAD TO NEW
PUMP
Peel the white sticker from the rectangular rubber
pad and attach the sticky side to the drain pump.
White Sticker
Rubber Pad -
Sticky side up
Snap
Ring
White
Drain
Pipe
31-1000617 Rev. 0