Subscribe to Our Youtube Channel
Related Manuals for WTI MPC Series
Summary of Contents for WTI MPC Series
- Page 1 WTI Part No. 13813 Rev. A MPC Series Managed Power Controllers Models Covered: MPC-8H-1 MPC-8H-2 MPC-16H-1 MPC-16H-2 MPC-20V-1 MPC-20V-2 Rack Mounting Options...
- Page 2 Rack Mounting Options for MPC Units The MPC offers a variety of different mounting options that allow the unit to be easily mounted in almost any equipment rack available. In addition to the standard "L" brackets included with all units, MPC-20V series units can also be mounted using standard mounting buttons, "Hook"...
- Page 3 MPC Managed Power Controllers - Rack Mounting Options Figure 1: Mounting Holes; MPC-20V Back Panel Equipment Rack MPC-20V Unit Retaining Screws “L ” Bracket Figure 2: Attaching the "L" Brackets to the Equipment Rack (MPC-20V Shown) Attaching the "L" Brackets to the Equipment Rack: Determine which direction the MPC unit will face in the rack, then line the "U"...
- Page 4 MPC Managed Power Controllers - Rack Mounting Options Mounting Buttons The Mounting Buttons allow MPC-20V (vertical) units to be mounted in any equipment rack that includes mounting button holes, as shown in Figure 4. Depending on the location of the mounting button holes in your equipment rack, this can allow the MPC-20V to be mounted on the posts at the rear of the equipment rack, or in some cases, even mounted on the outside of the rack corner posts.
- Page 5 MPC Managed Power Controllers - Rack Mounting Options Hook Bracket Mounting (MPC-20V Only) The Hook Brackets allow MPC-20V (vertical) units to be easily mounted in Dell™ style equipment racks. The Hook Brackets can be used to mount the MPC-20V in any rack that includes Dell™...
- Page 6 MPC Managed Power Controllers - Rack Mounting Options Zero-U Pocket Bracket Mounting (MPC-20V Only) The Zero-U Pocket Brackets allow you to mount the MPC-20V in APC style racks, that ® include a pocket or channel for zero unit mounting as shown in Figures 6 and 7. The Zero-U Pocket Brackets allow MPC-20V units to be mounted directly into the channel or pocket at the rear of the rack, and can either be nested inside the pocket in order to use as little space as possible, or mounted on top of the pocket, in order...
- Page 7 Refer to the electrical safety warnings in Chapter 4 and at the beginning of the MPC Series user's guide, and then disconnect the input power supply cables from the MPC-20V unit. Next, remove the output cables from the MPC-20V, noting the precise plug/location where each output cable was plugged in.
- Page 8 5 Sterling, Irvine, California 92618-2517 (800) 854-7226 • (954) 586-9950 info@wti.com • http://www.wti.com...
Need help?
Do you have a question about the MPC Series and is the answer not in the manual?
Questions and answers