Installing The Coaxial Line To The; Installing And Screwing The Spk Support - Huawei U9200 Maintenance Manual

8.14 Installing the Coaxial Line to the Front Cover
Step 1 Take a piece of coaxial line.
Secure one end tightly to a port on the
main board.
Step 4 Wait until the entire coaxial
line is squeezed into the groove.

8.15 Installing and Screwing the SPK Support

Step 1 Take an antenna support, and check
whether it is in good condition. Tear off the liner
on the back of the support.
Align one side of the SPK support
with the front cover.
Step 3 Install the SPK support into the
front cover as shown in the figure above.
(2012-06-13)
U9200 Maintenance Manual
Step 2 Secure the other end tightly to
another port on the main board.
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
Step 3 Squeeze the coaxial line into
the groove in a direction away from
the port.
Step 5 The positioned coaxial line is shown
in the figure above.
Keep the SPK clip
towards left.
Step 2 Align the right end of the SPK with the
support, and then press it into the support.
Step 4 Run the electric screwdriver to screw the SPK
support with two square head screws.
INTERNAL
Page 37 of 80