Advertisement
Table of Contents
Polaris Slingshot Hood Vent Inserts Kit
If you have any questions during the installation you can call or text
(864) 907-6004. Email support is also available - Tech@ddmworks.com.
Tools Needed for installation -
- Scissors
DDM-21-7
This DDMWorks mesh inserts are designed to
install into the hood vents we make, reducing the
road debris and moisture coming up from the
road.
If you are pretty handy with tools the inserts can
be installed in about 15 minutes, however we
suggest that you schedule an hour for the
installation just incase.
Tools Needed for Install
1
DDMWorks - 119A Hwy 183
Piedmont, SC 29673
Tech Support Call, Text or Email:
(864) 907-6004,
Advertisement
Table of Contents
Related Manuals for DDMWorks DDM-21-7
Summary of Contents for DDMWorks DDM-21-7
- Page 1 If you have any questions during the installation you can call or text (864) 907-6004. Email support is also available - Tech@ddmworks.com. Tools Needed for Install Tools Needed for installation -...
- Page 2 Installation of hood inserts 1. To install the hood vents the first thing is to make sure the bottom of your vents are nice and clean. Use a clean towel with soap and water to clean them the best you can. Then make sure to dry them thoroughly before starting the next step.
- Page 3 Installation of hood inserts 5. Make sure to press the tape down to secure it to the hood vent. Then start to peel off the red backing on the tape. 6. Once the backing is all peeled off, the insert gets installed, you will want to install the wide end of the insert first.
- Page 4 Congratulations! You have finished the install. All of us here at DDMWorks thank you for your purchase and hope you enjoy your new mesh inserts! If you have any questions feel free to give us a call or text us at 864-907-6004.
Need help?
Do you have a question about the DDM-21-7 and is the answer not in the manual?
Questions and answers