Magnavox MWR20V6 Service Manual page 24

Message
This program is not allowed to
be recorded on this disc.
This disc is protected and not
recordable.
Disc is full.
(No area for new recording)
You cannot record more than
99 titles on one disc.
(The maximum is 99.)
You cannot record more than
999 chapters on one disc.
(The maximum is 999.)
You cannot record on this disc
as Control Information is full.
You cannot record on the disc
as Power Calibration Area is
full.
This disc is already finalized.
Can not record on this disc.
If an error occurs during the timer recording, one of the following error numbers (40 to 42) or the above error
messages (error number: 1 to 39) is displayed on the recording menu after timer recording.
(Once the timer programming list with error indication is displayed, the program line(s) with error will be cleared
only after the programs are cancelled and reset to the timer standby mode.)
(In the case of the error occurs during setting the timer programming, no error messages is displayed.)
A program with the error number is grayed out and asterisked on the timer programming list.
Message
Error message is not
displayed.
Solution
Insert a ver.1.1 CPRM
compatible DVD-RW disc.
Release the disc protect
setting in the Disc Setting
menu.
Insert the recordable disc with
enough recording space.
Delete unnecessary titles.
Delete unnecessary chapter
markers.
Delete unnecessary titles.
Insert a new disc.
Release the finalizing for this
disc.
Repeat the same operation.
Timer Programming
* JAN/01 12:57AM
2. ---
3. ---
4. ---
5. ---
6. ---
7. ---
8. ---
Solution
- Set the timer programming
correctly.
- Set the timer programming
before the start time.
- Insert a recordable videotape
with a record tab.
Turn the power on and set the
clock correctly then set timer
programming again.
Insert the recordable disc.
1-10-3
Error
Error Description
No.
During the CGMS picture (possible to
record once) input. (Disc which is not for
28
the correspondence to VR Format
CPRM)
29 Disc Protected Disc.
30 No avilable recording space.
Its recording capacity has been reached.
31
(Video Format Disc)
Its recording capacity has been reached.
32
(VR Format Disc)
The 999 chapter has been reached. (VR
33
Format Disc)
There is not space to record field of
34
control information.
35 PCA is Full. (in REC start)
36 It is finalized. (Video Format Disc)
37 Access to Memory Area range outside.
38 Sector Address is wrong.
39 BUP writing error of chapter editing.
VCR DVD
1:57AM 8 DVD E40 The speed mode changes
to the error number.
Error
Error Description
No.
- Some portion has not been recorded
because of program overlapping.
40 - Recording did not start at the start time.
- No Videotape is inserted.
Videotape ran out during recording.
41 Power failed
42 No disc when recording
Priority
12
7
5
7
8
9
10
4
6
-
-
-
Priority
-
-
-
E9A80FIS